LEXUS RX 300

1998-2003 of release

Repair and car operation



Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
- Трансмиссионная a line
   The general information
   Removal and installation карданного a shaft
   Removal, dismantling, assemblage and installation of forward power shafts
   Removal, dismantling, assemblage and installation of back power shafts
   Replacement of a forward epiploon of back differential
   Replacement of lateral epiploons of back differential
   Removal and installation of the case of back differential, differential dismantling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections


7bd329e4


Replacement of a forward epiploon of back differential

Components of installation of a forward epiploon of back differential

1 — the Lining
2 — the Stopper of a jellied aperture
3 — Карданный a shaft
4 — the Connecting flange

5 — the Epiploon
6 — Маслоотражательное a ring
7 — the Forward bearing
8 — the bearing Prorate
9 — the Drain stopper


 PERFORMANCE ORDER

  1. Lower oil of back differential.
  2. Remove карданный a shaft (the Door Section see).
  3. Chisel and hammer расчеканьте a nut.
  4. Keeping a connecting flange by means of the special adaptation, turn out a nut.
  1. Remove a connecting flange by means of the special adaptation.
  1. By means of the special adaptation remove an epiploon, and then – маслоотражательное a ring.
  1. Remove the forward bearing and by means of a special stripper, remove the bearing prorate.
  2. Establish on a shaft the new prorate of the bearing and the bearing.
  3. Establish маслоотражательное a ring and запрессуйте a new epiploon on depth of 2.0 mm.
  4. Put on epiploon edges universal greasing.
  5. By means of the special adaptation establish on a shaft a connecting flange.
  6. Oil a carving of a fixing nut of a flange for differential and keeping a flange from проворачивания, tighten a nut with effort of 108 Nanometers.
  7. Adjust a preliminary tightness of a leading gear wheel.
  8. Rivet a nut.
  9. Establish карданный a shaft and fill differential with oil according to requirements of Specifications of Head Transmissionnaja a line.