LEXUS RX 300

1998-2003 of release

Repair and car operation



Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
- Suspension bracket and steering
   The general information
   + Forward suspension bracket
   + Back suspension bracket
   + Steering
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections


The general information

At performance of repair or service of components of a suspension bracket and a steering often there are problems with отворачиванием the "become attached" bolts and nuts. Located under the bottom of the car fixture elements constantly are exposed to external influences both in due course are exposed to corrosion and partially collapse. Brute force application at отпускании such "become attached" fixture is interfaced to risk of its damage. To begin with moisten not giving in отворачиванию an element with a small amount of a special getting liquid (type WD40), having allowed last it is good to impregnate rust layers. A wire brush remove external adjournment from accessible sites of carving surfaces. Sometimes sharp blow by a hammer on a nut through выколотку helps to destroy a rust filling backlashes between coils of a carving joint, - try not to admit carving damage as a result соскакивания выколотки. Use at отворачивании the "become attached" fixture long воротка allows to increase considerably the put twisting moment, however it is necessary to remember, that application of extension pieces complete with drives of ratchet type is interfaced to risk of failure of the returnable mechanism, and also with possibility of reception of a trauma.

Damaged in process отпускания the fixture is subject to replacement without fail.

As the majority of procedures described in the present chapter is made on the car lifted over the earth, it is necessary to take care beforehand of variants of its reliable fixing in the lifted position, – prepare strong props. For поддомкрачивания the car use hydraulic jacks подкатного type, – remember, that the onboard jack entering into a standard complete set is intended only for time поддомкрачивания the car at replacement of the failed wheel. The hydraulic jack can be used also for posting of some components of a suspension bracket at performance of this or that procedure.

Work under the car kept in lifted position only by means of jacks is not supposed!






7bd329e4