LEXUS RX 300

1998-2003 of release

Repair and car operation



Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
- Suspension bracket and steering
   The general information
   + Forward suspension bracket
   - Back suspension bracket
      Removal, dismantling, assemblage and installation of a nave of a back wheel
      Removal, dismantling, assemblage and installation of a rack of a suspension bracket
      Removal and installation of the stabilizer of a suspension bracket
      Removal and installation of levers of a back suspension bracket
   + Steering
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections


Removal and installation of levers of a back suspension bracket

Components of installation of levers of a back suspension bracket

1 — the Back stretcher
2 — the Holder
3 — the Cross-section lever №1
4 — the Clown of adjustment of convergence of back wheels
5 — the Cross-section lever №2

6 — the Cable of a drive of a lay brake
7 — the Longitudinal lever
8 — Draught of the gauge of adjustment of an inclination of headlights
9 — the Washer


 PERFORMANCE ORDER

  1. Remove a back wheel.
  2. Remove the central and back sections of an exhaust pipe.
  3. Turn out a bolt and remove from a body an arm of a cable of a lay brake.
  4. At a corresponding complete set turn out a nut and disconnect draught of the gauge of adjustment of an inclination of headlights from cross-section draught №2 back suspension brackets.
  5. Turn out two bolts, a nut and remove the longitudinal lever of a suspension bracket.
  6. Put adjusting labels on the clown of adjustment of convergence of back wheels and on a stretcher.
  7. Turn out a bolt and a nut, remove the clown and disconnect cross-section draught №2 from a stretcher.
  8. Turn out a bolt and a nut of fastening of cross-section draught №2 to ступичной to assemblage and remove draught.
  9. Turn out a bolt and a nut of fastening of cross-section draught №1 to ступичной to assemblage and disconnect from it draught.
  10. Ослабьте an adjusting bolt of the cross-section lever №1 to a back stretcher.

Do not remove a bolt entirely.

  1. Prop up a back stretcher a jack, turn out 4 nuts, 2 bolts and remove two holders from a back stretcher.
  2. Lower a jack, completely turn out a bolt of fastening of the cross-section lever №1 to a back stretcher and remove the lever.
  3. Installation is made upside-down. In summary check up and if necessary adjust corners of installation of back wheels.