LEXUS RX 300

1998-2003 of release

Repair and car operation



Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
- Systems of cooling of the engine, heating, ventilation and air conditioning
   - System of cooling of the engine
      The general information and safety measures
      Removal, check and installation of the water pump
      Removal, check and thermostat installation
      Check of components of system of cooling
      Removal and installation of a radiator and fans
   + Systems of heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections


Removal, check and installation of the water pump

Bolts of fastening of the water pump

The water pump is located under a cover №3 belts of drive ГРМ and fastens to the block of cylinders four bolts and two nuts.

 PERFORMANCE ORDER

  1. Empty cooling system (the Section Replacement of a cooling liquid (ОЖ see)).
  2. Remove обтекатель a windscreen and top распорку an impellent compartment (the Body see the Head).
  3. Remove a belt of drive ГРМ, its cogwheels and a roller №2 (see Has undressed Removal, check and installation of a belt of drive ГРМ him натяжителя, a pulley and a cogwheel of a cranked shaft, cogwheels of camshafts and intermediate rollers).
  4. Remove a cover №3 belts of drive ГРМ (see Has undressed Removal, dismantling, check, assemblage and installation of a head of cylinders and its components).
  5. Turn out fixture of the water pump and remove it together with a lining.
  6. Examine a control aperture in the pump case on presence of leaks and if necessary replace the water pump.
  7. Rotating a roller of the water pump a hand, check up smoothness and ease of a course of its bearing. If necessary replace the water pump.
  8. Having taken advantage of a case, check up components of drive ГРМ (see Has undressed Removal, check and installation of a belt of drive ГРМ him натяжителя, a pulley and a cogwheel of a cranked shaft, cogwheels of camshafts and intermediate rollers).
  9. Installation is made in an order, the return to an order of dismantle of components. Use a new lining of the pump, tighten fixture with demanded efforts.

At installation of a lining do not oil it.