LEXUS RX 300

1998-2003 of release

Repair and car operation



Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
- The engine
   The general information and preparatory operations
   Check компрессионного pressure
   Check of the engine by means of the vacuum gauge
   Reduction of the piston of the first cylinder in position of the top dead point (ВМТ)
   Check of a corner of an advancing of ignition
   Removal, check and installation of a belt of drive ГРМ it натяжителя, a pulley and a cogwheel of a cranked shaft, cogwheels of camshafts and intermediate rollers
   Removal, dismantling, check, assemblage and installation of a head of cylinders and its components
   Removal and engine installation, check of support
   The block of cylinders
   Check Д/В of pressure of impellent oil
   Removal, dismantling, check, assemblage and installation of the oil pump and the pallet картера
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections


Check of a corner of an advancing of ignition

The corner of an advancing of ignition is defined ECU and is not subject to manual adjustment.


 PERFORMANCE ORDER

  1. Remove a decorative cover of the engine, having turned out 3 nuts of its fastening and having removed its clamps.
  1. Warm up the engine to normal working temperature.
  1. Connect scanner OBD-II to socket DLC №3, being guided by the instruction of the manufacturer of the scanner.
  1. Connect a stroboscope clip to a wire conclusion.
  1. Increase turns of the engine to 2500 rpm approximately for 90 seconds and check up idling turns – they should make 700 50 rpm. Leave the engine to work on single turns.

At check of turns of idling following conditions should be satisfied:

  • The engine should be прогрет;
  • The air cleaner should be established, and air hoses and tubes should be reliably and are correctly connected;
  • All additional equipment should be switched off;
  • All vacuum lines should be reliably and are correctly connected;
  • Sockets of electroconducting of system of injection should be reliably connected;
  • Check of a corner of an advancing of ignition the Engine should meet the requirements of Specifications of the Head;
  • АТ should be established in neutral position.
  1. If idling turns mismatch requirements of Specifications of the Head the Engine, check up valve IAC and воздухозаборный a path.
  1. Перемкните contacts TE1 and E1 socket DLC №1 also establish АТ in neutral position.
  1. Having shined with a stroboscope a scale on a cover of a belt of drive ГРМ, consider a corner of an advancing of ignition.
  1. Remove a crosspiece from socket DLC №1 and once again check up a corner of an advancing of ignition.
  2. Compare the received values to requirements of Specifications of the Head the Engine.
  3. Disconnect a stroboscope and scanner OBD-II.
  4. Establish a decorative cover of the engine.





7bd329e4