LEXUS RX 300

1998-2003 of release

Repair and car operation



Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
- The power supply system and release of the fulfilled gases
   - The power supply system
      The general data and security measures
      Сбрасывание pressure in fuel system
      Principle of functioning of a control system of fuel injection
      Checks of system of injection
      Removal and installation of the fuel pump, the gauge of a stock of fuel and regulator of pressure of fuel
      Removal and installation of fuel distributive highways and injectors
      Removal and installation of a fuel tank and fuel lines
      Removal and air cleaner installation
      Removal, installation and adjustment of the case of a throttle and gauge TPS
      Removal and installation of components of system ACIS
   + Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections


7bd329e4


Removal, installation and adjustment of the case of a throttle and gauge TPS

Removal and installation

Components of installation of the case of a throttle

1 — the Lining
2 — the throttle Case
3 — Перепускной a hose of system of cooling
4 — the Cable of a drive throttle заслонки

5 — an air cleaner Hose
6 — the Vacuum hose
7 — the Air hose
8 — the Smoothing receiver

Components of assemblage of the case of a throttle

1 — Section №3 of the case of a throttle
2 — the Protective plate
3 — the Sealing ring
4 — Gauge TPS

5 — Section №1 of the case of a throttle
6 — the Lining
7 — Section №2 of the case of a throttle
8 — Valve IAC


 PERFORMANCE ORDER

  1. Empty system of cooling of the engine (the Section Replacement of a cooling liquid (ОЖ see)).
  2. Disconnect a cable of a drive throttle заслонки and remove an air cleaner hose (see Has undressed Removal and air cleaner installation).
  3. Separate sockets of electroconducting of gauge TPS and лапана IAC.
  4. Disconnect from the throttle case перепускные hoses of system of cooling of the engine, a hose подмешивания air, two hoses of giving of fuel evaporations and a vacuum hose.
  5. Give 3 nuts and remove the throttle case together with a lining.
  6. At installation use a new lining between the case of a throttle and воздухораспределителем. Tighten fixture with demanded efforts.
  7. At gauge TPS installation at first put it to the throttle case, having turned on a corner 3060 hailstones. Clockwise, and then fix the gauge, having turned it against an hour hand.

Adjustment

 PERFORMANCE ORDER

  1. Giving a counternut and the adjusting screw on the opening party, expose a backlash between a screw head and the throttle lever on the party №1 (illustrations see).
  2. Gradually tightening the screw, result it in position in which it starts to concern the lever.

Do not draw the screw. Then turn out the screw on a turn quarter. Also fix it in this position by a counternut.

  1. Repeat the described adjustment for the screw on the opening party.

The adjusting screw from position of contacts with the lever should be tightened on 1/23/4 a turn.

  1. In summary check up the throttle case (the Section of Check of system of injection see).