LEXUS RX 300

1998-2003 of release

Repair and car operation



Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
- The power supply system and release of the fulfilled gases
   - The power supply system
      The general data and security measures
      Сбрасывание pressure in fuel system
      Principle of functioning of a control system of fuel injection
      Checks of system of injection
      Removal and installation of the fuel pump, the gauge of a stock of fuel and regulator of pressure of fuel
      Removal and installation of fuel distributive highways and injectors
      Removal and installation of a fuel tank and fuel lines
      Removal and air cleaner installation
      Removal, installation and adjustment of the case of a throttle and gauge TPS
      Removal and installation of components of system ACIS
   + Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections


Removal and installation of fuel distributive highways and injectors

Do not drop injectors and do not subject to their loadings and deformations since thus it is possible to damage injectors.

Assemblage of fuel distributive highways and injectors

1 — the Tube and hoses подмешивания air
2 — the Clamp of connection of a fuel hose
3 — the Fuel distributive highway
4 — an injector Socket

5 — the Lining
6 — the Sealing ring
7 — the Prorate
8 — the Injector


 PERFORMANCE ORDER

  1. Remove an air cleaner sleeve.
  2. Remove assemblage воздухораспределителя (the Section Replacement, dismantling and block K/V assemblage see).
  3. Separate sockets of electroconducting of injectors.
  4. Disconnect a tube подмешивания air from скобы №1 fuel tubes then disconnect hoses подмешивания air from the inlet pipeline.
  5. Disconnect топливоподающую a tube from the fuel filter.
  6. Turn out 5 bolts and remove fuel distributive highways together with injectors and a fuel tube.
  7. Take from a fuel distributive highway of 4 prorates.
  8. Extend injectors from fuel distributive highways.
  9. Remove on two sealing rings and two linings from each injector.
  10. Check up injectors (the Section of Check of system of injection see).
  11. Installation is made in an order, the return to an order of dismantle of components. Use new sealing rings and linings, tighten fixture with demanded efforts.
  12. After installation make sure of absence of leaks of fuel.





7bd329e4