LEXUS RX 300

1998-2003 of release

Repair and car operation



Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
- Трансмиссионная a line
   The general information
   Removal and installation карданного a shaft
   Removal, dismantling, assemblage and installation of forward power shafts
   Removal, dismantling, assemblage and installation of back power shafts
   Replacement of a forward epiploon of back differential
   Replacement of lateral epiploons of back differential
   Removal and installation of the case of back differential, differential dismantling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections


Removal and installation карданного a shaft

Components карданного a shaft

1 — Forward section карданного a shaft
2 — Пыльник
3 — the Bearing of a back support
4 — the Plate
5 — the Adjusting washer
6 — the Bearing of a forward support

7 — the Washer
8 — Intermediate section карданного a shaft
9 — the Back flange
10 — the Forward flange
11 — Back section карданного a shaft

Removal

 PERFORMANCE ORDER

  1. Put adjusting labels on a forward flange and on the hinge.
  1. Give 4 nuts and remove bolts and washers.
  2. Remove assemblage of forward section карданного a shaft, trying not to damage an epiploon.
  3. Закупорьте an aperture in АТ to prevent oil leaks.
  4. Squeeze out a pedal of a brake and keep it in this position.
  5. Turn out 6 connecting bolts on a half-turn.

Fill in the hinge rags that it did not concern a cover.

  1. Put adjusting labels on a back flange and on the hinge.
  2. Give 4 nuts and remove bolts and washers.
  3. Turn out bolts of fastening of support and remove assemblage of the central and back sections карданного a shaft.
  4. Put labels on connection of the central and back sections карданного a shaft.

Do not put a label a chisel.

  1. Completely turn out 6 connecting bolts, remove two washers and divide the central and back sections карданного a shaft.

Installation

 PERFORMANCE ORDER

  1. Join the central and back sections карданного a shaft, having levelled the adjusting labels put on them at separation.
  2. Establish two washers and tighten by hand 6 connecting bolts.
  3. Temporarily establish the central basic bearing.
  4. Level the labels put at removal on the back hinge and on back differential.
  5. Tighten 4 bolts with effort of 74 Nanometers.
  6. Take out from АТ заглушку and establish a holder.
  7. Level the labels put at removal on the forward hinge and on intermediate section карданного of a shaft.
  8. Tighten 4 bolts with effort of 74 Nanometers.
  9. Squeeze out a pedal of a brake and having asked the assistant to keep it, tighten connecting bolts with effort of 27 Nanometers.
  1. Make sure, that all hinges карданного a shaft are focused.
  1. At the unloaded car adjust distance between the back party of a cover and shaft.
  1. At the unloaded car adjust distances between end faces of basic bearings and end faces of support.
  1. Tighten bolts of fastening of support with effort of 37 Nanometers.
  2. Make sure, that axes of support are perpendicular axes карданного a shaft.





7bd329e4