LEXUS RX 300

1998-2003 of release

Repair and car operation



Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
- Brake system
   The general information and security measures
   Removal, installation and check of pedals of brake system
   Check of brake system through a socket of the module of management
   Removal and installation of the tank and the main brake cylinder (ГТЦ)
   Removal, check and installation of the amplifier of brakes
   Replacement brake колодок
   Removal, dismantling, check, assemblage and installation of supports of brake mechanisms
   Dismantling, check and assemblage of a lay brake
   Check of the valve of distribution of brake effort
   Removal and installation of the activator of brakes
   Removal and installation of wheel gauges
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections


7bd329e4


Removal and installation of the tank and the main brake cylinder (ГТЦ)

Installation and assemblage ГТЦ components

1 — Collars
2 — tank GTTS Hoses
3 — the Lining
4 — the Reception union
5 — the Piston №1
6 — the Piston №2

7 — the Spring
8 — Case GTTS
9 — the Pin
10 — Consolidation
11 — the Tank
12 — the Filter
13 — the Cover


 PERFORMANCE ORDER

  1. Remove air cleaner assemblage (see the Head of the Power supply system and release of the fulfilled gases).
  2. Pump out from ГТЦ a brake liquid by means of a syringe or спринцовки.
  3. Separate socket Д/В of low level of a brake liquid.
  4. Put adjusting labels on hoses of tank GTTS and collars, ослабьте collars and remove hoses from the tank.
  5. Turn out a bolt and remove assemblage of the tank of a brake liquid.
  6. Put adjusting labels on hoses of tank GTTS and collars, ослабьте collars and remove hoses with ГТЦ.
  7. Disconnect from the tank 2 brake tubes.
  8. Turn out two nuts and remove ГТЦ together with a lining.
  9. If necessary disassemble ГТЦ.
  10. Before installation clear ГТЦ and the tank the compressed air and adjust length of a press rod of the amplifier of brakes (see Has undressed Removal, check and installation of the amplifier of brakes).
  11. After installation fill the tank with a brake liquid, pump over brake system and check up it on leaks.
  12. Adjust a pedal of a working brake (the Section Check and adjustment of a course of pedals of a working and lay brake see).